Set Sntp Poll-Timeout; Clear Sntp Poll-Timeout - Enterasys SecureStack C2 Configuration Manual

set sntp poll-timeout

Use this command to set the poll timeout (in seconds) for a response to a unicast SNTP request.
Syntax
set sntp poll-timeout timeout
Parameters
timeout
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the SNTP poll timeout to 10 seconds:
C2(su)->set sntp poll-timeout 10

clear sntp poll-timeout

Use this command to clear the SNTP poll timeout.
Syntax
clear sntp poll-timeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the SNTP poll timeout:
C2(su)->clear sntp poll-timeout
Specifies the poll timeout in seconds. Valid values are 1 to 30.
set sntp poll-timeout
SecureStack C2 Configuration Guide 12-31