Clear Summertime - Enterasys SecureStack C2 Configuration Manual

clear summertime

Syntax
set summertime recurring start_week start_day start_month start_hr_min end_week
end_day end_month end_hr_min [offset_minutes]
Parameters
start_week
start_day
start_hr_min
end_week
end_day
end_hr_min
offset_minutes
Defaults
If an offset is not specified, none will be applied.
Mode
Switch command, read‐write.
Example
This example shows how set daylight savings time to recur starting on the first Sunday of April at
2 a.m. and ending the last Sunday of October at 2 a.m. with an offset time of one hour:
C2(su)->set summertime recurring first Sunday April 02:00 last Sunday October
02:00 60
clear summertime
Use this command to clear the daylight savings time configuration.
Syntax
clear summertime
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
3-18 Basic Configuration
Specifies the week of the month to restart daylight savings time. Valid
values are: first, second, third, fourth, and last.
Specifies the day of the week to restart daylight savings time.
Specifies the time of day to restart daylight savings time. Format is
hh:mm.
Specifies the week of the month to end daylight savings time.
Specifies the day of the week to end daylight savings time.
Specifies the time of day to end daylight savings time. Format is hh:mm.
(Optional) Specifies the amount of time in minutes to offset daylight
savings time from the non‐daylight savings time system setting. Valid
values are 1 ‐ 1440.