Commands; Show Flowcontrol; Set Flowcontrol - Enterasys SecureStack C2 Configuration Manual

show flowcontrol

Commands

For information about...
show flowcontrol

set flowcontrol

show flowcontrol
Use this command to display the flow control state.
Syntax
show flowcontrol
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the port flow control state:
C2(su)->show flowcontrol
Flow control status: enabled
set flowcontrol
Use this command to enable or disable flow control.
Syntax
set flowcontrol {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
5-18 Port Configuration
Enables or disables flow control settings.
Refer to page...
5-18
5-18