Set Port Protected; Show Port Protected - Enterasys SecureStack C2 Configuration Manual

set port protected

Use this command to specify a port to be protected and assign the port to a group of protected
ports. A port can be assigned to only one group.
Syntax
set port protected port-string group-id
Parameters
port‐string
group‐id
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to assign ports
C2(rw)->set port protected ge.1.1-3 1

show port protected

Use this command to display information about the ports configured for protected mode.
Syntax
show port protected [port-string] | [group-id]
Parameters
port‐string
group‐id
Defaults
If no parameters are entered, information about all protected ports is displayed.
Mode
Read‐only.
Specifies the port or ports to be protected.
Specifies the id of the group to which the ports should be assigned. Id can
range from 0 to 2.
.1.1 through
ge
(Optional) Specifies the port or ports for which to display information.
(Optional) Specifies the id of the group for which to display information.
Id can range from 0 to 2.
.1.3 to protected port group 1:
ge
SecureStack C2 Configuration Guide 5-47
set port protected