Set Maclock Trap - Enterasys SecureStack C2 Configuration Manual

set maclock trap

Example
This example shows how to move all current first arrival MACs to static entries on ports
C2(rw)->set maclock move ge.3.1-40
set maclock trap
Use this command to enable or disable MAC lock trap messaging.
Syntax
set maclock trap port-string {enable | disable}
Parameters
port‐string
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Usage
When enabled, this feature authorizes the switch to send an SNMP trap message if an end station
is connected that exceeds the maximum values configured using the set maclock firstarrival and
set maclock static commands. Violating MAC addresses are dropped from the device's (or
stack's) filtering database.
Example
This example shows how to enable MAC lock trap messaging on
C2(su)->set maclock trap ge.2.3 enable
18-56 Security Configuration
Specifies the port on which MAC lock trap messaging will be enabled or
disabled. For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 5‐2.
Enables or disables MAC lock trap messaging.
ge
.2.3:
ge
.3.1‐40: