Clear Dhcp Pool Client-Name; Set Dhcp Pool Bootfile - Enterasys SecureStack C2 Configuration Manual

Mode
Switch command, read‐write.
Example
This example configures the client name "appsvr1" to the manual binding pool "manual2."
C2(rw)->set dhcp pool manual2 client-identifier 01:22:33:44:55:66
C2(rw)->set dhcp pool manual2 host 10.12.1.10 255.255.255.0
C2(rw)->set dhcp pool manual2 client-name appsvr1

clear dhcp pool client-name

Use this command to delete a DHCP client name from an address pool for manual binding.
Syntax
clear dhcp pool poolname client-name
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the client name from the manual binding pool "manual2."
C2(rw)->clear dhcp pool manual2 client-name

set dhcp pool bootfile

Use this command to specify a default boot image for the DHCP clients who will be served by the
address pool being configured.
Syntax
set dhcp pool poolname bootfile filename
Parameters
poolname
filename
Defaults
None.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the boot image file name.
clear dhcp pool client-name
SecureStack C2 Configuration Guide 14-19