Clear Dhcp Pool Dns-Server; Set Dhcp Pool Domain-Name - Enterasys SecureStack C2 Configuration Manual

clear dhcp pool dns-server

Syntax
set dhcp pool poolname dns-server address [address2 ... address8]
Parameters
poolname
address
address2 ... address8
Defaults
None.
Mode
Switch command, read‐write.
Example
This example assigns a DNS server at 10.14.10.1 to the address pool "'auto1."
C2(rw)->set dhcp pool auto1 dns-server 10.14.10.1
clear dhcp pool dns-server
Use this command to remove the DNS server list from the address pool being configured.
Syntax
clear dhcp pool poolname dns-server
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the DNS server list from the address pool "auto1."
C2(rw)->clear dhcp pool auto1 dns-server

set dhcp pool domain-name

Use this command to specify a domain name to be assigned to DHCP clients served by the
address pool being configured.
14-24 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the IP address of a DNS server.
(Optional) Specifies, in order of preference, up to 7 additional DNS
server addresses.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.