Ip Pimsm Staticrp; Ip Pimsm Enable - Enterasys SecureStack C2 Configuration Manual

ip pimsm staticrp

Example
This example shows how to globally enable and disable PIM:
C2(su)->router(Config)# ip pimsm
C2(su)->router(Config)# no ip pimsm
ip pimsm staticrp
This command is used to create a manual Rendezvous Point IP address for the PIM‐SM router.
The no form of this command removes a previously configured RP.
Syntax
ip pimsm staticrp ipaddress groupadress groupmask
no ip pimsm staticrp ipaddress groupadress groupmask
Parameters
ipaddress
groupadress
groupmask
Defaults
None.
Mode
Global Router configuration: C2(su)‐>router(Config)#
Example
This example shows how to set an RP for a specific multicast group.
C2(su)->router(Config)# ip pimsm staticrp 192.15.18.3 224.0.0.0 240.0.0.0

ip pimsm enable

This command sets the administrative mode of PIM‐SM multicast routing on a routing interface to
enabled. By default, PIM is disabled on all IP interfaces. The no form of this command disables
PIM on the specific interface.
Syntax
ip pimsm enable
no ip pimsm enable
Parameters
None.
Defaults
None.
17-46 IPv4 Routing Protocol Configuration
The IP address of the Rendezvous Point
The group address supported by the Rendezvous Point
The group mask for the group address