Set Pwa - Enterasys SecureStack C2 Configuration Manual

Table 18-8 show pwa Output Details (Continued)
Output
PWA IP Address
PWA Protocol
PWA Enhanced
Mode
PWA Logo
PWA Guest
Networking Status
PWA Guest Name
PWA Guest
Password
PWA Redirect Time
Port
Mode
Auth Status
Quiet Period
MaxReq

set pwa

Use this command to enable or disable port web authentication.
Syntax
set pwa {enable | disable}
Parameters
enable | disable
What It Displays...
IP address of the end station from which PWA will prevent network access until the
user is authenticated. Set using the set pwa ipaddress command as described in
"set pwa ipaddress" on page 18-62.
Whether PWA protocol is CHAP or PAP. Default setting of PAP can be changed
using the set pwa protocol command as described in
page 18-62.
Whether PWA enhanced mode is enabled or disabled. Default state of disabled can
be changed using the set pwa enhancedmode
enhancedmode" on page 18-68.
Whether the Enterasys Networks logo will be displayed or hidden at user login.
Default state of enabled (displayed) can be changed using the set pwa displaylogo
command as described in
Whether PWA guest user status is disabled or enabled with RADIUS or no
authentication. Default state of disabled can be changed using the set pwa
gueststatus command as described in
Guest user name for PWA enhanced mode networking. Default value of "guest" can
be changed using the set pwa guestname command as described in
guestname" on page 18-63.
Guest user's password. Default value of an empty string can be changed using the
set pwa guestpassword command as described in
page 18-64.
Time in seconds after login success before the user is redirected to the PWA home
page.
PWA port designation.
Whether PWA is enabled or disabled on his port.
Whether or not the port state is disconnected, authenticating, authenticated, or held
(authentication has failed).
Amount of time a port will be in the held state after a user unsuccessfully attempts to
log on to the network. Default value of 60 can be changed using the set pwa
quietperiod command as described in
Maximum number of log on attempts allowed before transitioning the port to a held
state. Default value of 2 can be changed using the set pwa maxrequests command
as described in "set pwa maxrequest" on page 18-66.
Enables or disables port web authentication.
command as described in
"set pwa displaylogo" on page 18-61.
"set pwa gueststatus" on page 18-64.
"set pwa
"set pwa quietperiod" on page 18-65.
SecureStack C2 Configuration Guide 18-59
set pwa
"set pwa protocol" on
"set pwa
"set pwa
guestpassword" on