Enterasys SecureStack C2 Configuration Manual page 182

set port lacp
aadminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync
| lacpcollect |
lacpdist | lacpdef |
lacpexpire
aportpri aportpri
asyspri asyspri
enable
disable
padminkey
padminkey
padminport
padminport
padminportpri
padminportpri
padminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync
| lacpcollect |
lacpdist | lacpdef |
lacpexpire
padminsysid
padminsysid
padminsyspri
padminsyspri
Defaults
At least one parameter must be entered per port‐string.
If enable or disable are not specified, port(s) will be enabled with the LACP parameters entered.
5-44 Port Configuration
Sets the port's actor LACP administrative state to allow for:
lacpactive ‐ Transmitting LACP PDUs.
lacptimeout ‐ Transmitting LACP PDUs every 1 sec. vs 30 sec. (default).
lacpagg ‐ Aggregation on this port.
lacpsync ‐ Transition to synchronization state.
lacpcollect ‐ Transition to collection state.
lacpdist ‐ Transition to distribution state.
lacpdef ‐ Transition to defaulted state.
lacpexpire ‐ Transition to expired state.
Sets the port's actor port priority. Valid values are 0 ‐ 65535, with lower
values designating higher priority.
Sets the port's actor system priority. The LACP implementation on the
SecureStack C2 device uses this value to determine aggregation
precedence when there are two devices competing for the same
aggregator. Valid values are 0 ‐ 65535, with higher precedence given to
lower values.
Note: Only one LACP system priority can be set on a SecureStack
C2 device, using either this command, or the set lacp asyspri
command ("set lacp
(Optional) Enables LACPDU processing on this port.
(Optional) Disables LACPDU processing on this port.
Sets a default value to use as the port's partner admin key. Only ports
with matching admin keys are allowed to aggregate. Valid values are 1 ‐
65535.
Sets a default value to use as the port's partner admin value. Valid values
are 1 ‐ 65535.
Sets a default value to use as the port's partner port priority. Valid values
are 0 ‐ 65535, with lower values given higher priority.
Sets a port's partner LACP administrative state. See aadminstate for valid
options.
Sets a default value to use as the port's partner system ID. This is a MAC
address.
Sets a default value to use as the port's partner priority. Valid values are 0
‐ 65535, with lower values given higher priority.
asyspri" on page 5-37).