Example Cli Properties Configuration; Cli Properties Display Commands; Cli Properties Show Commands - Enterasys C5G124-24 Configuration Manual

Table 3-2 CLI Properties Configuration Commands (continued)
Task
Set the time (in minutes) an idle console or Telnet
CLI session will remain connected before timing out.
Refer to the CLI Reference for your switch model for more information about each command.

Example CLI Properties Configuration

In this example, the prompt is changed and a login banner is added.
C5(rw)->set prompt "Switch 1"
Switch 1(rw)->
Switch 1(rw)->set banner login "There is nothing more important than our
customers."

CLI Properties Display Commands

Table 3-3 lists CLI properties show commands.
Table 3-3 CLI Properties Show Commands
Task
Display the banner message that will display at pre
and post session login.
Display the number of columns for the terminal
connected to the device's console port.
Display the current screen length.
Display the time (in seconds) an idle console or
Telnet CLI session will remain connected before
timing out.
Refer to the CLI Reference for your switch model for a description of the output of each command.
Command
set logout timeout
Command
show banner
show width
show length
show logout
Fixed Switching Configuration Guide 3-7
Configuring CLI Properties