Clear Cos Reference - Enterasys SecureStack C2 Configuration Manual

Mode
Switch command, read‐only.
Example
This example shows the Class of Service IRL references for port group 1.0. Note that not all of the
100 possible references are displayed in this output example.
C2(su)->show cos reference irl 1.0
Group Index Reference Type Rate Limiter
----------- --------- ---- ------------
1.0
1.0
1.0
1.0
...
1.0
1.0
1.0

clear cos reference

Use this command to clear the Class of Service inbound rate limiting reference configuration.
Syntax
clear cos reference irl {all | group-type-index reference}
Parameters
irl
all
group‐type‐index
reference
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the CoS inbound rate limiting reference configuration for all
groups:
C2(su)->clear cos reference irl all
0 irl none
1 irl 1
2 irl none
3 irl none
97 irl none
98 irl none
99 irl none
Specifies that IRL references are being cleared.
Clear all groups indexes and references.
Specifies an inbound rate limiting port group/type index. Valid entries
are in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
Clear a specific reference for the specified port group.
clear cos reference
SecureStack C2 Configuration Guide 9-29