Show Ip Vrrp; Configuring Pim-Sm; Purpose - Enterasys SecureStack C2 Configuration Manual

show ip vrrp

Mode
Router configuration: C2(su)‐>router(Config‐router)#
Example
This example shows how to enable VRRP on the VLAN 1 interface, VRID 1:
C2(su)->router(Config)#router vrrp
C2(su)->router(Config-router)#enable vlan 1 1
show ip vrrp
Use this command to display VRRP routing information.
Syntax
show ip vrrp
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display VRRP information
C2(su)->router(Config)#show ip vrrp
-----------VRRP CONFIGURATION-----------
Vlan
2

Configuring PIM-SM

PIM is an advanced routing feature that must be enabled with a license key. If you have purchased an
advanced license key, and have enabled routing on the device, you must activate your license as described
in "Activating Licensed
purchase an advanced routing license, contact Enterasys Networks Sales.

Purpose

To enable and configure Protocol Independent Multicast in Sparse Mode (PIM‐SM). This protocol
provides the means of dynamically learning how to forward multicast traffic in an environment
where group members are sparsely located throughout the network and bandwidth is limited. In
situations where members are densely located and bandwidth is plentiful, DVMRP would suffice
(see "Configuring DVMRP" on page 17‐31.)
17-44 IPv4 Routing Protocol Configuration
Vrid State Owner
1 Initialize
* Advanced License Required *
Features" on page 15-3 in order to enable the PIM command set. If you wish to
AssocIpAddr Priority
0 25.25.2.1 100