Set Macauthentication Portquietperiod; Clear Macauthentication Portquietperiod - Enterasys SecureStack C2 Configuration Manual

set macauthentication portquietperiod

This sets the number of seconds following a failed authentication before another attempt may be
made on the port.
Syntax
set macauthentication portquietperiod time port-string
Parameters
time
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets port 1 to wait 5 seconds after a failed authentication attempt before a new
attempt can be made:
C2(su)->set macauthentication portquietperiod 5 ge.1.1

clear macauthentication portquietperiod

This sets the quiet period back to the default value.
Syntax
clear macauthentication portquietperiod [port-string]
Parameters
port‐string
Defaults
If a port‐string is not specified then all ports will be set to the default port quiet period.
Mode
Switch command, read‐write.
Example
This example resets the default quit period on port 1:
C2(su)->clear macauthentication portquietperiod ge.1.1
Period in seconds to wait after a failed authentication
Specifies the ports for which the quit period is to be applied. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 5‐2.
(Optional) Specifies the ports for which the quiet period is to be reset. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 5‐2.
set macauthentication portquietperiod
SecureStack C2 Configuration Guide 18-25