Clear Tftp Timeout; Set Tftp Retry - Enterasys SecureStack C2 Configuration Manual

clear tftp timeout

Mode
Switch command, read‐write.
Example
This example sets the timeout period to 4 seconds.
C2(rw)->set tftp timeout 4
clear tftp timeout
Use this command to reset the TFTP timeout value to the default value of 2 seconds.
Syntax
clear tftp timeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the timeout value to the default of 2 seconds.
C2(rw)-> clear tftp timeout

set tftp retry

Use this command to configure how many times TFTP will resend a packet, either an
acknowledgement packet or a data packet.
Syntax
set tftp retry retry
Parameters
retry
Defaults
None.
Mode
Switch command, read‐write.
3-44 Basic Configuration
Specifies the number of times a packet will be resent. The valid range is
from 1 to 1000. Default value is 5 retries.