Enterasys SecureStack C2 Configuration Manual page 30

Structure of This Guide
Chapter
how to enable or disable switch ports and configure switch port settings, including port speed,
duplex mode, auto‐negotiation, flow control, port mirroring, link aggegation and broadcast
suppression.
Chapter
rights, target addresses, and notification parameters.
Chapter
parameters for the device, including bridge priority, hello time, maximum aging time and forward
delay; and how to review and set Spanning Tree port parameters, including port priority and path
costs. Configuring the SpanGuard and Loop Protect functions is also described.
Chapter
operation for each port, establish VLAN forwarding (egress) lists, route frames according to
VLAN ID, display the current ports and port types associated with a VLAN and protocol, create a
secure management VLAN, and configure ports on the device as GVRP‐aware ports.
Chapter
roles or profiles based on business‐specific use of network services; how to permit or deny access
to specific services by creating and assigning classification rules which map user profiles to frame
filtering policies; how to classify frames to a VLAN or Class of Service (CoS); and how to assign or
unassign ports to policy profiles so that only ports activated for a profile will be allowed to
transmit frames accordingly.
Chapter
priority of each port and configure a rate limit for a given port and list of priorities.
Chapter
Protocol (IGMP) settings for multicast filtering.
Chapter
manage general switch settings, how to monitor network events and status,and how to configure
SNTP and node aliases.
Chapter
which provides comprehensive network fault diagnosis, planning, and performance tuning
information and allows for interoperability between SNMP management stations and monitoring
agents.
Chapter
parameters, how to review and configure DHCP address pools, and how to display DHCP server
information.
Chapter
activate a license.
Chapter
to configure IP interface settings, how to review and configure the routing ARP table, how to
review and configure routing broadcasts, how to configure PIM, and how to configure IP routes.
Chapter
routing protocols, including RIP, OSPF, DVMRP, IRDP, and VRRP.
Chapter
EAPOL, how to configure RADIUS server, Secure Shell server, MAC authentication, MAC
locking, Port Web Authentication, and IP access control lists (ACLs).
xxviii About This Guide
5, Port Configuration, describes how to review and configure console port settings, and
6, SNMP Configuration, describes how to configure SNMP users and user groups, access
7, Spanning Tree Configuration, describes how to review and set Spanning Tree bridge
8, 802.1Q VLAN Configuration, describes how to create static VLANs, select the mode of
9, Policy Classification Configuration, describes how to create, change or remove user
10, Port Priority and Rate Limiting Configuration, describes how to set the transmit
11, IGMP Configuration, describes how to configure Internet Group Management
12, Logging and Network Management, describes how to configure Syslog, how to
13, RMON Configuration, describes how to use RMON (Remote Network Monitoring),
14, DHCP Server Configuration, describes how to review and configure DHCP server
15, Preparing for Router Mode, provides information about router modes and how to
16, IP Configuration, describes how to enable IP routing for router mode operation, how
17, IPv4 Routing Protocol Configuration, describes how to configure IP routing and
18, Security Configuration, describes how to configure 802.1X authentication using