Show Linkflap Parameters Output Details - Enterasys SecureStack C2 Configuration Manual

show linkflap
Usage
The linkflap default conditions are shown in the following table.
Linkflap Parameter
Linkflap global state
Linkflap port state
Linkflap action
Linkflap interval
Linkflap maximum allowed link downs per 10 seconds
Linkflap threshold
(number of allowed link down transitions before action is taken)
Examples
This example shows how to display the global status of the link trap detection function:
C2(rw)->show linkflap globalstate
Linkflap feature globally disabled
This example shows how to display ports disabled by link flap detection due to a violation:
C2(rw)->show linkflap downports
Ports currently held DOWN for Linkflap violations:
None.
This example shows how to display the link flap parameters table:
C2(rw)->show linkflap parameters
Linkflap Port Settable Parameter Table (X means error occurred)
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table 5‐3 provides an explanation of the show linkflap parameters command output.
Table 5-3 show linkflap parameters Output Details
Output...
Port
LF Status
Actions
Threshold
Interval
Downtime
5-22 Port Configuration
LF Status Actions
--------- -------
disabled .......
enabled D..S..T
disabled ...S..T
Threshold Interval
---------- ----------
10 5
3 5
10 5
What it displays...
Port designation.
Link flap enabled state.
Actions to be taken if the port violates allowed link flap behavior.
D = disabled, S = Syslog entry will be generated, T= SNMP trap
will be generated.
Number of link down transitions necessary to trigger the link flap
action.
Time interval (in seconds) for accumulating link down transitions.
Interval (in seconds) port(s) will be held down after a link flap
violation.
Default Condition
Disabled
Disabled
None
5
20
10
Downtime
----------
300
300
300