Ip Igmp Version; Show Ip Igmp Interface - Enterasys SecureStack C2 Configuration Manual

ip igmp version

Use this command to set the version of IGMP running on the router. The no form of this command
resets IGMP to the default version of 2 (IGMPv2).
Syntax
ip igmp version version
no ip igmp
Parameters
version
Defaults
None.
Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the IGMP version to version 1 on VLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp version 1

show ip igmp interface

Use this command to display information about one or more IGMP routing interfaces.
Syntax
show ip igmp interface [vlan vlan-id]
Parameters
vlan vlan‐id
Defaults
If not specified, information will be displayed for all VLANs configured for IGMP routing.
Mode
Any router mode.
Specifies the IGMP version number to run on the router. Valid values are
1, 2, or 3.
(Optional) Displays information for one or more VLANs.
SecureStack C2 Configuration Guide 11-11
ip igmp version