Set Switch - Enterasys SecureStack C2 Configuration Manual

Mode
Switch command, read‐only.
Example
This example shows how to display data and error information on stack ports:
C2(ro)->show switch stack-ports
Switch
------ ---------- ------ ---------- ---------- ------ ---------- --------
1

set switch

Use this command to assign a switch ID, to set a switch's priority for becoming the management
switch if the previous management switch fails, or to change the switch unit ID for a switch in the
stack.
Syntax
set switch {unit [priority value | renumber newunit]}
Parameters
unit
priority value
renumber newunit
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to assign priority 3 to switch 5:
C2(su)->set switch 5 priority 3
This example shows how to renumber switch 5 to switch 7:
C2(su)->set switch 5 renumber 7
------------TX-------------- ------------RX-----------
Data
Stacking Rate
Port (Mb/s) (Errors/s)
Up 0 0
Down 0 0
Specifies a unit number for the switch. Value can range from 1 to 8.
Specifies a priority value for the unit. Valid values are 1 to 15 with higher
values assigning higher priority.
Specifies a new number for the unit.
Error
Rate Total
Errors
0
0
Note: This number must be a previously unassigned unit ID number.
Data Error
Rate Rate Total
(Mb/s) (Errors/s) Errors
0 0 0
0 0 0
SecureStack C2 Configuration Guide 2-9
set switch