Ip Igmp Startup-Query-Interval; Ip Igmp Startup-Query-Count - Enterasys SecureStack C2 Configuration Manual

ip igmp startup-query-interval

ip igmp startup-query-interval
Use this command to set the interval between general IGMP queries sent on startup. The no form
of this command resets the IGMP startup query interval to the default value of 31 seconds.
Syntax
ip igmp startup-query-interval time
no ip igmp startup-query-interval
Parameters
time
Defaults
None.
Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the IGMP startup query interval to 100 seconds on VLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp startup-query-interval 100

ip igmp startup-query-count

Use this command to set the number of IGMP queries sent out on startup, separated by the
startup‐query‐interval (as described in "ip igmp startup‐query‐interval" on page 11‐14). The no
form of this command resets the IGMP startup query count to the default value of 2.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
Parameters
count
Defaults
None.
Mode
Interface configuration: C2
Example
This example shows how to set the IGMP startup query count to 10 onVLAN 1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip igmp startup-query-count 10
11-14 IGMP Configuration
Specifies the IGMP startup query interval. Valid values are from 1 to 300
seconds. The default value is 31 seconds.
Specifies the number of IGMP startup queries. Valid values are from 1 to
20. The default value is 2.
(su)‐>router(Config‐if(Vlan 1))#