Clear Cos Settings; Show Cos Settings - Enterasys SecureStack C2 Configuration Manual

The CoS IRL reference field is optional, as rate limits are not required. The IRL reference does
not assign an inbound rate limit but points to the CoS IRL Reference Mapping Table. This
reference may be thought of as the virtual rate limiter that will assign the physical rate limiter
defined by the IRL Reference Mapping Table, described in "set cos reference" on page 9‐27.
Example
This example shows how to create CoS entry 8 with a priority value of 3:
C2(rw)->set cos settings 8 priority 3

clear cos settings

Use this command to clear Class of Service entry settings.
Syntax
clear cos settings cos-list {[all] | [priority] [tos-value] [irl-reference]}
Parameters
cos‐list
all
priority
tos‐value
irl‐reference
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the priority for CoS entry 8:
C2(rw)->clear cos settings 8 priority

show cos settings

Use this command to display Class of Service parameters.
Syntax
show cos settings [cos-list]
Parameters
cos‐list
Defaults
If not specified, all CoS entries will be displayed.
Specifies a Class of Service entry to clear.
Clears all settings associated with this entry.
Clears the priority value associated with this entry.
Clears the Type of Service value associated with this entry.
Clear the IRL reference associated with this entry.
(Optional) Specifies a Class of Service entry to display.
clear cos settings
SecureStack C2 Configuration Guide 9-21