show lacp
Parameters
port‐string
Defaults
If port‐string is not specified, link aggregation information for all LAGs will be displayed.
Mode
Switch command, read‐only.
Usage
Each SecureStack C2 module provides 6 virtual link aggregator ports, which are designated in the
CLI as lag.0.1 through lag.0.6. Once underlying physical ports (that is,
an aggregator port, the resulting aggregation will be represented as one Link Aggregation Group
(LAG) with a lag.x.x port designation.
Example
This example shows how to display lacp information for lag.0.1
output fields.
C2(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs:
Aggregator: lag.0.1
System Identifier:
System Priority:
Attached Ports:
Table
5‐6 provides an explanation of the command output.
Table 5-6 show lacp Output Details
Output
Global Link
Aggregation state
Single Port LAGs
Aggregator
Actor
Partner
System Identifier
5-36 Port Configuration
(Optional) Displays LACP information for specific LAG port(s). Valid
port designations are lag.0.1 ‐ 6.
Actor
00:01:F4:5F:1E:20
Admin Key:
Oper Key:
ge.1.1
ge.1.3
What It Displays...
Shows if LACP is enabled or disabled on the switch.
Displays if the single port LAG feature has been enabled on the switch. See
singleportlag" on page 5-40 for more about single port LAG.
LAG port designation. Each SecureStack C2 module provides 6 virtual link
aggregator ports, which are designated in the CLI as lag.0.1 through lag.0.6. Once
underlying physical ports (for example, ge.x.x) are associated with an aggregator
port, the resulting Link Aggregation Group (LAG) is represented with a lag.x.x port
designation.
Local device participating in LACP negotiation.
Remote device participating in LACP negotiation.
MAC addresses for actor and partner.
disabled
Partner
00:11:88:11:74:F9
32768
32768
32768
.x.x) are associated with
ge
.
The following table describes the
32768
0
"set lacp