Monitor Session Source - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.4 Port Mirroring
Syntax
Call up the command with the following parameters:
no monitor session <session-id(1)> destination
{interface <interface-type><interface-id>}
The parameters have the following meaning:
Parameter
session-id
interface
interface-
type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The destination for the mirroring of a port is deleted.
Further notes
You configure the destination for mirroring a port with the
command.
You end and delete a session with the
You display the configuration settings with the
12.4.4.7

monitor session source

Description
With this command, you configure the source for mirroring a port or a VLAN.
Requirement
● You are in the Global Configuration mode.
● Monitoring is enabled
The command prompt is as follows:
cli(config)#
588
Description
Number of the session
7 parallel sessions are possible only with port-
based mirroring and their ports must not overlap.
Keyword for a an interface description
Type or speed of the interface
Slot no. and port no. of the interface
monitor session ... destination
command.
no monitor session
show monitor session
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Values
1 .. 7
-
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
command.