Autoboot Enable - Allied Telesis AR2050V Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT

AUTOBOOT ENABLE

autoboot enable
Overview This command enables the device to restore a release file and/or a configuration
file from external media, such as a USB storage device.
When the Autoboot feature is enabled, the device looks for a special file called
autoboot.txt on the external media. If this file exists, the device will check the
key and values in the file and recover the device with a new release file and/or
configuration file from the external media. An example of a valid autoboot.txt
file is shown in the following figure.
Figure 2-1:
Use the no variant of this command to disable the Autoboot feature.
autoboot enable
Syntax
no autoboot enable
Default The Autoboot feature operates the first time the device is powered up in the field,
after which the feature is disabled by default.
Mode Global Configuration
Example To enable the Autoboot feature, use the command:
awplus#
awplus#
awplus(config)#
Related create autoboot
Commands
show autoboot
show boot
C613-50186-01 Rev B
C
OMMANDS
Example autoboot.txt file
[AlliedWare Plus]
Copy_from_external_media_enabled=yes
Boot_Release=AR2050V-5.4.7-1.1.rel
Boot_Config=network1.cfg
configure terminal
configure terminal
no autoboot enable
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
110