Directing Rpm Probes To Select Bgp Routers; Verifying An Rpm Configuration; Verifying Rpm Services; Verifying Rpm Statistics - Juniper J-Series Administration Manual

Directing RPM Probes to Select BGP Routers

If a Services Router has a large number of BGP neighbors configured, you can direct
(filter) the RPM probes to a selected group of BGP neighbors rather than to all the
neighbors. To identify the BGP routers to receive RPM probes, you can configure
routing instances.
The sample RPM configuration in Table 145 on page 285 sends RPM probes to the
BGP neighbors in routing instance R1.
To direct RPM probes to select BGP neighbors:
1.
2.
3.
4.
Table 145: Directing RPM Probes to Select BGP Routers
Task
Navigate to the Services>RPM>BGP
level in the configuration hierarchy.
Configure routing instance RI1
RPM probes to BGP neighbors within the
routing instance.

Verifying an RPM Configuration

To verify an RPM configuration, perform these tasks:
Navigate to the top of the configuration hierarchy in either the J-Web or CLI
configuration editor.
Perform the configuration tasks described in Table 145 on page 285.
If you are finished configuring the router, commit the configuration.
To verify the configuration, see "Verifying an RPM Configuration" on page 285.
J-Web Configuration Editor
1. In the J-Web interface, select
Configuration>View and
Edit>Edit Configuration.
2. Next to Services, click Configure
or Edit.
3. Next to Rpm, select the Yes check
box and click Configure or Edit.
4. Next to Bgp, click Configure or
Edit.
1. Next to Routing instances, click
to send
Add new entry.
2. In the Routing instance name box,
type .
RI1
3. Click OK.
Verifying RPM Services on page 286
Verifying RPM Statistics on page 286
Verifying RPM Probe Servers on page 288
Chapter 14: Configuring RPM Probes
CLI Configuration Editor
From the [edit] hierarchy level, enter
edit services rpm bgp
Enter
set routing-instances RI1

Verifying an RPM Configuration

285