Steering Rack Boot On-Vehicle Inspection; Tie-Rod / Rack Boot Removal And Installation - Suzuki Liana RH413 Service Manual

• For installing each part, refer to respective procedures as indicated in the following.
Model
Exhaust pipe No.2
2WD Mounting member
Engine rear mounting bracket
Drive shaft
Exhaust No. 1 and No. 2 pipe
Suspension control arm ball stud "Front Suspension Frame Removal and Installation in Section 2B"
4WD Engine rear mounting nut
Suspension frame
Transfer stiffener
Transfer assembly
• After installation, be sure to fill specified power steering fluid and bleed air.
• Check toe setting. Adjust as required. Refer to "Front Wheel Alignment Inspection and Adjustment in Section 2B".

Steering Rack Boot On-Vehicle Inspection

Check boot for any crack and damage which, means
there is some possibility of rusty gear, entry of dust or
lack of grease. Also, check if any of such faulty
conditions exists.

Tie-Rod / Rack Boot Removal and Installation

Removal
1) Remove steering gear box from vehicle referring to
"P/S Gear Box Removal and Installation".
2) For ease of adjustment after installation, make
marking (4) of tie-rod end lock nut position of tie-rod
thread.
3) Loosen tie-rod end lock nut (2) and remove tie-rod
end.
4) Remove boot wire and clip.
5) Remove boot (3) from tie-rod (1).
Part
"Exhaust Pipe Removal and Installation in Section 1K"
"Front Suspension Frame Removal and Installation in Section 2B"
"Front Suspension Frame Removal and Installation in Section 2B"
"Front Drive Shaft Assembly Removal and Installation in Section 3A"
"Exhaust Pipe Removal and Installation in Section 1K"
"Front Suspension Frame Removal and Installation in Section 2B"
"Front Suspension Frame Removal and Installation in Section 2B"
"Transfer Dismounting and Remounting in Section 3C"
"Transfer Dismounting and Remounting in Section 3C"
S3RH0A6306006
I2RH01630012-01
S3RH0A6306013
I2RH01630030-01
Power Assisted Steering System:
Section
6) Unbend three bent portions (1) of tie-rod lock
washer, and then remove tie-rod (2) from rack (3).
4. Aluminum plate
5. Vise
6C-14
I3RH0A630004-01