Dtc Clearance; Scan Tool Data - Suzuki Liana RH413 Service Manual

4E-14 ABS:
DTC (displayed DTC (indicated
on SUZUKI scan by ABS
tool) warning lamp)
C1061
C1063
C1071

DTC Clearance

WARNING
!
When performing a driving test, select a safe
place where there is neither any traffic nor
any traffic accident possibility and be very
careful during testing to avoid occurrence of
an accident.
After repair or replace malfunction part(s), clear all DTCs
by performing the following procedure or using SUZUKI
scan tool.
Not Using SUZUKI Scan Tool
1) Turn ignition switch OFF.
2) Using service wire (4), connect diagnosis switch
terminal (2) of monitor connector (blue) (1) to ground
terminal (3).
3) With connection described in Step 2) maintained,
turn ignition switch ON.
4) Repeat disconnecting and reconnecting of service
wire between diagnosis and ground terminals 5
times or more at about 1 sec. interval within 10
seconds.
ABS warning lamp flashing
pattern
61
63
71
S3RH0A4504006
I2RH01450004-01
ABS pump motor and/or motor relay circuit
MCODE00061-0-01
Fail-safe relay
MCODE00063-0-01
ABS control module
MCODE00071-0-01
O: Open
S: Short
5) Turn ignition switch OFF and disconnect service wire
from monitor coupler.
6) Perform "Driving Test" (Step 2 of "ABS Check") and
"DTC Check" and confirm that normal DTC (DTC 12)
is displayed not malfunction DTC.
Using SUZUKI Scan Tool
1) Connect SUZUKI scan tool to data link connector in
the same manner as when making this connection
for DTC check.
2) Turn ignition switch to ON position.
3) Erase DTC according to instructions displayed on
scan tool. Refer to scan tool operator's manual for
further derails.
4) After completing the clearance, turn ignition switch
OFF and disconnect scan tool from data link
connector.
5) Perform "Driving Test" (Step 2 of "ABS Check") and
"DTC Check" and confirm that NO DTC is displayed
on scan tool.

Scan Tool Data

The parameter data below are values measured with the
scan tool when the normally operating vehicle is under
the following conditions. When taking measurements for
comparison by using the scan tool, be sure to check that
the vehicle is under the following conditions.
• Apply parking brake and block wheels.
• Ignition switch ON.
• Turn OFF air conditioner (if equipped).
• Apply no load to power steering (if equipped). (Don't
turn it)
• Turn OFF all electric loads (except ignition).
Diagnostic Items
I3RH0A450003-01
T: About 10 seconds
V: About 1 seconds
S3RH0A4504007