Master Cylinder Assembly Disassembly And Assembly - Suzuki Liana RH413 Service Manual

4) Connect fluid level switch connector (1) of reservoir.
5) [For RH steering vehicle]
Install air cleaner outlet hose.
6) Fill reservoir with specified brake fluid up to its MAX
mark.
7) After completing the work, bleed air and check brake
pedal for play.
Master Cylinder Assembly Disassembly and
Assembly
Disassembly
1) [For LH steering vehicle not equipped with ABS]
Remove piston stopper bolt (1).
Brake Control System and Diagnosis:
2) [For LH steering vehicle equipped with ABS]
Push in primary piston (1) to remove secondary
piston stopper pin (2) from master cylinder as
shown.
3) Remove circlip (1).
4) Remove primary piston. Then remove secondary
piston by blowing compressed air (2) into hole. Be
cautious during removal as secondary piston jumps
out.
WARNING
!
Do not apply too highly compressed air
which will cause piston to jump out of
I3RH0A410024-01
cylinder. Place a cloth to prevent piston from
damage. It should be taken out gradually with
moderately compressed air. Do not place
your fingers in front of piston when using
compressed air.
S3RH0A4106013
Assembly
CAUTION
!
I2RH01410024-01
• Never use any mineral oil such as
kerosene oil and gasoline when washing
and assembling parts.
• Check inside of cylinder wall, pistons and
cup seals are free from any foreign objects
such as dust and dirt and use case not to
cause any damage with a tool during
assembly.
• Do not drop parts. Do not use any part
which has been dropped.
4A-17
I2RH01410025-01
I2RH01410026-01