Suzuki Liana RH413 Service Manual page 691

NOTE
When replacing reduction drive gear, replace
it together with reduction driven gear as a
set.
Special tool
(A): 09951–18210
(B): 09944–78210
2. Stand that can slightly lift transaxle case.
15) Install parking lock pawl (1) and spring (2). Apply A/T
fluid to parking lock pawl shaft, then insert it into
transaxle case.
16) Install new planetary ring gear subassembly (1) to
reduction drive gear (3) by using special tools and
hydraulic press.
CAUTION
!
• Do not reuse planetary ring gear
subassembly. Otherwise it may cause
damage to planetary gear unit and/or
reduction gears.
• Do not use transaxle case as groundwork
to press fit planetary ring gear
subassembly.
• Do not give load more than 20 kN (2000 kg,
4410 Ib) with hydraulic press. Otherwise, it
may result in damaging reduction drive
gear bearing.
Automatic Transmission/Transaxle:
Special tool
(A): 09951–18210
(B): 09944–78210
17) Using a small torque wrench, while turning to
counter drive gear 100 rpm and measure the
preload.
I2RH0B510270-01
CAUTION
!
• Do not tighten nut over the specifications
so that reduction drive gear nut would not
be broken.
• Carry out this procedure on rubber mat in
order not to damage transaxle case.
Reduction drive gear bearing preload measured
as starting torque
Standard: 0.05 – 0.35 N⋅m (0.5 – 3.5 kg-cm, 0.036
– 0.253 lb-ft)
I2RH0B510271-01
2. Stand that can slightly lift transaxle case.
5A-143
I2RH0B510272-01
I2RH0B510273-01