Suzuki Liana RH413 Service Manual page 425

7) Install retainer stoppers (2).
NOTE
Change shape of retainer stopper depending on position of tooth on retainer (1).
Tightening torque
Retainer stopper bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
8) Check gear tooth contact.
Apply red lead paste to tooth of drive bevel gear and turn it by hand to check its contact with drive bevel pinion.
Check contact pattern, referring to the following chart. If contact pattern is not normal, readjust or replace as
necessary according to instruction in chart.
NOTE
• Apply red lead paste all around bevel gear but not so much as to become sticky.
• Be careful not to turn bevel gear more than one full revolution, for it will hinder accurate check.
Gear tooth contact
Tooth contact pattern
I3RH0A320006-01
I3RH01322042-01
High contact
Pinion is positioned too far from the center of drive
bevel gear.
1. Increase thickness of pinion height adjusting
shim and position pinion closer to gear center.
2. Adjust drive bevel gear backlash to
specification.
I3RH01322043-01
Differential:
Diagnosis and remedy
Normal
3B-12