Side Sensor Inspection; Driver Air Bag (Inflator) Module Removal And Installation - Suzuki Liana RH413 Service Manual

8B-101 Air Bag System:

Side Sensor Inspection

CAUTION
!
• Never disassemble side sensor.
• Sensor should be replaced when it was
dropped from a height of 90 cm (3 ft) or
more.
• Check sensor (1) for dents, crack, deformation.
• Check sensor connector (sensor side and harness
side), lock mechanism or sensor lead wire for
damage, crack, scorching or melting.
• Check connector terminals for bent, corrosion or rust.
If any faulty condition is found in above checks, replace.
1
Driver Air Bag (Inflator) Module Removal and
Installation
WARNING
!
• Never attempt to disassemble or repair the
driver air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System" before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
undeployment of the air bag when
necessary.
Removal
1) Disconnect negative battery cable at battery
terminal.
2) Disable air bag system. Refer to "Disabling Air Bag
System".
3) Loosen driver air bag (inflator) module mounting
bolts (1) till it turns freely, pull them out and fix them
to bolt clamps.
S3RH0A8206012
4) Remove air bag (inflator) module from steering
wheel.
5) Disconnect driver air bag (inflator) module connector
(1) of driver air bag (inflator) module (3) and horn
connector (2) as shown in the figure.
a) Unlock lock button (3).
b) With lock button unlocked, disconnect connector.
I3RH0A820065-01
S3RH0A8206005
WARNING
!
Special care is necessary when handling and
storing a live (undeployed) air bag (inflator)
module. Observe "Precautions on Handling
and Storage of Air Bag Components".
Otherwise, personal injury may result.
Installation
1) Connect horn connector (2) securely.
2) Connect connector (1) of driver air bag (inflator)
module (3) securely as shown in the figure.
a) Connect connector.
b) Lock connector with lock button.
2
1
3
1
b)
3
I3JA01820031-01
a)
b)
I3JA01820084-01
2
a)
I3JA01820085-01