Suzuki Liana RH413 Service Manual page 1197

8) Using new brush, apply sufficient amount of primer
onto glass along glass edge.
NOTE
• Be sure to refer to maker's instruction for
proper handling and drying time.
• Do not apply primer on outside of ceramic
coated surface.
• Do not touch primer coated surface.
Width applied primer for windshield
"a": 15 mm (0.59 in.)
"b": 22 mm (0.87 in.)
"c": 6 mm (0.24 in.)
"a"
1
2
"b" "c"
1. Molding
2. Spacer
9) Apply primer for molding along molding surface all
around.
10) Apply adhesive (1) referring to figure.
NOTE
• Press glass (2) against fittings surface of
body panel quickly after adhesive (1) is
applied.
• Use of rubber sucker grip is helpful to hold
and carry glass after adhesive (1) is
applied.
• Perform steps 8) to 9) within 10 min. to
ensure sufficient adhesion.
• Be sure to refer to adhesive maker's
instruction for proper handling and drying
time.
• Start from bottom side of glass (2).
• Be careful not to damage primer.
Adhesive amount specifications and position for
windshield
Width "a": Approx. 7 mm (0.27 in.)
Height "b": Approx. 15 mm (0.59 in.)
Position "c": Approx. 11 mm (0.43 in.) for front,
rear and upper sections
Position "d": Approx. 17 mm (0.67 in.) for bottom
section
I4RH01950003-01
1
2
11) Holding rubber sucker grips (1), place glass onto
body by aligning mating marks marked in step 3) and
press it.
Glass / Windows / Mirrors:
"a"
3
2
"d"
"a"
"b"
4
3. Molding
4. Windshield glass spacer
9E-6
2
3
2
I3RH0A950007-01
I2RH01950050-01