Steering Rack Boot Inspection; Tie-Rod / Rack Boot Removal And Installation - Suzuki 2006 SX4 Service Manual

Hide thumbs Also See for 2006 SX4:
Table of Contents

Advertisement

2) Install steering gear case to suspension frame (3) as
follows.
a) Set member bracket (2) to steering gear case
(1).
b) Install all steering gear case mounting bolts by
hand.
c) Tighten steering mounting bolts in numerical
order and specified torque.
Tightening torque
Steering gear case mounting bolt (a): 70 N·m (
7.0 kgf-m, 51.0 lb-ft)
3) Install front suspension frame with steering gear
case to vehicle referring to Steps 4) – 22) of "Front
Suspension Frame, Stabilizer Bar and/or Bushing
Removal and Installation (2WD Model) in Section
2B" or "Front Suspension Frame, Stabilizer Bar and/
or Bushing Removal and Installation (4WD Model) in
Section 2B", and then install steering gear case to
vehicle.
4) Connect torque sensor connector and P/S motor
connector to steering gear case.
5) Be sure that steering wheel and brake discs (right &
left) are all straight-ahead position and then insert
steering lower shaft (5) into steering pinion shaft (3)
with matching marks (4).
6) Tighten steering shaft joint lower bolt (1) and upper
bolt (2) to specified torque (tighten lower side first
and then tighten upper side).
Tightening torque
Steering lower shaft assembly upper joint bolt
(a): 25 N·m (2.5 kgf-m, 18.5 lb-ft)
Steering lower shaft assembly lower joint bolt
(b): 25 N·m (2.5 kgf-m, 18.5 lb-ft)
5
1, (b)
4
3
7) Install steering joint cover.

Steering Rack Boot Inspection

Hoist vehicle.
Inspect each boot for tear. A torn boot allows entry of
dust and water which can cause wear to steering rack
and pinion to produce noise as well as rust to result in
malfunction of steering system.
Even if boot tear is small, replace with new one.
Also, check each boot for dent. If there is a dent, keep
boot in most compressed state for some seconds to
correct dent.
Boots should be visually inspected for any damage, dent
and tear during every periodical inspection at specified
intervals and whenever vehicle is hoisted for any other
purpose.
I7RW01632009-01

Tie-Rod / Rack Boot Removal and Installation

Removal
1) Remove steering gear case assembly referring to
"Steering Gear Case Assembly Removal and
Installation".
2) Remove member bracket from steering gear case
assembly.
3) For ease of adjustment after installation, make
marking (1) of tie-rod end lock nut position of tie-rod
thread.
4) Loosen tie-rod end lock nut and remove tie-rod end.
5) Remove boot band (2) and clip (1).
6) Remove boot from tie-rod.
2, (a)
5
1, (b)
I5RW0A630020-01
Power Assisted Steering System:
6C-39
S6RW0C6306007
I2RH01630012-01
S6RW0C6306008
I4RS0A630044-01
IYSQ01630034-01

Advertisement

Table of Contents
loading

Table of Contents