Rear Knuckle Removal And Installation (2Wd Model) - Suzuki Liana RH413 Service Manual

2C-20 Rear Suspension:
Rear Knuckle Removal and Installation (2WD
Model)
Removal
1) Hoist vehicle and remove wheel hub referring to
"Wheel Hub with Wheel Bearing and Wheel Stud
Removal and Installation (2WD Model)".
2) Remove ABS wheel speed sensor harness bracket
(if equipped) and E-ring (1) securing brake hose.
3) Disconnect brake pipe (1) from wheel cylinder (2)
and put wheel cylinder bleeder plug cap (3) onto
pipe to prevent fluid from spilling.
4) Remove ABS wheel speed sensor from knuckle, if
equipped.
5) Remove brake back plate (1) from knuckle.
6) Loosen control rod outer bolts, trailing rod rear bolt
and strut bracket nuts.
S3RH0A2306022
7) Disconnect control rods No.1 (2) and No.2 (3) from
knuckle (1).
8) Disconnect trailing rod (4) from knuckle (1).
9) Remove knuckle (2) from strut.
I4RH01230014-01
I4RH01230015-01
I2RH01230049-01
I2RH01230050-01
I2RH01230051-01