Repair Instructions; Blower Unit Components; Blower Unit Removal And Installation - Suzuki Liana RH413 Service Manual

Blower Unit Components

1. Blower unit case
2. Blower motor assembly

Blower Unit Removal and Installation

Removal
1) Set air intake switch to fresh air mode with ignition
switch on, and then turn off ignition switch after three
seconds. (It takes about three seconds to move over
air intake selector door to fresh air position.)
2) Disconnect negative (–) cable at battery.
3) Remove glove box.
4) Remove instrument panel passenger lower member
(1).

Repair Instructions

4
5
7
2
8
3. Air intake selector door
4. Air intake selector link
S3RH0A7106002
I3RH0A710027-01
Heater and Ventilation:
3
1
5. Air intake control actuator
6. Fresh air inlet duct
5) Disconnect main harness connector (1) and clamp,
air intake control actuator connector (2) and blower
motor connector (3).
6) Remove blower motor relay (4) from blower unit.
2
1
4
7) Remove blower unit (1) from vehicle body.
Installation
Reverse removal procedure to install blower unit noting
the following instruction.
• When installing each part, be careful not to catch any
cable or wiring harness.
7A-13
S3RH0A7106001
6
I3RH0A710009-01
7. Blower unit lower case
8. Blower motor relay
3
I3RH0A710010-01
1
I3RH0A710028-01