Abs Warning Lamp Check; Ebd Warning Lamp (Brake Warning Lamp) Check - Suzuki Liana RH413 Service Manual

Step 2: Driving Test
Test drive the vehicle at 40 km/h for more than a minute and check if any trouble symptom (such as abnormal lighting
of ABS warning light) exists.
If the malfunction DTC is confirmed again at ignition switch ON, driving test as described is not necessary. Proceed to
Step 3.
Step 3: DTC Check
Recheck DTC referring to "DTC Check".
Step 4: ABS Check
According to ABS Check for the DTC confirmation in Step 3, locate the cause of the trouble, namely in a sensor,
switch, wire harness, connector, actuator assembly or other part and repair or replace faulty parts.
Step 5: Brakes Diagnosis
Check the parts or system suspected as a possible cause referring to "Brakes Symptom Diagnosis in Section 4A" and
based on symptoms appearing on the vehicle (symptom obtained through Steps 1 and 2 and repair or replace faulty
parts, if any).
Step 6: Check for Intermittent Problem
Check parts where an intermittent trouble is easy to occur (e.g., wire harness, connector, etc.), referring to
"Intermittent and Poor Connection Inspection in Section 00" and related circuit of trouble code recorded in Step 1 to 3.
Step 7: Final Confirmation Test
Confirm that the problem symptom has gone and the ABS is free from any abnormal conditions. If what has been
repaired is related to the malfunction DTC, clear the DTC once and perform test driving and confirm that no DTC is
indicated.

ABS Warning Lamp Check

1) Turn ignition switch ON.
2) Check that ABS warning lamp (1) comes ON for
about 2 seconds and then goes off.
If any faulty condition is found, advance to "ABS
Warning Lamp Does Not Come ON at Ignition Switch
ON", "ABS Warning Lamp Comes ON Steady" or
"ABS Warning Lamp Flashes Continuously while
Ignition Switch Is ON".
EBD Warning Lamp (Brake Warning Lamp)
S3RH0A4504002
Check
1) Turn ignition switch ON with parking brake applied.
2) Check that EBD warning lamp (brake warning lamp)
3) Release parking brake with ignition switch ON and
1
I3RH0A450012-01
NOTE
Perform this check on a level place.
(1) is turned ON.
check that EBD warning lamp (brake warning lamp)
goes off.
If it doesn't go off, go to "EBD Warning Lamp (Brake
Warning Lamp) Comes ON Steady".
ABS: 4E-11
S3RH0A4504003
1
BRAKE
I3RH0A450011-01