Suzuki Liana RH413 Service Manual page 809

Assembly
Reverse disassembly procedure for assembly, noting the
following.
1) Apply grease to oil seal lip (1). Apply power steering
fluid to sliding surface of the shaft (2), and then insert
shaft in the pump body.
"A": Grease 99000–25010
2) Apply power steering fluid to O-rings (1) and fit them
to pump body.
3) Install side plate (1) to pump body.
NOTE
Carefully align the dowel pins on the side
plate (1) at bolt hole (2) as shown in the
figure.
4) Apply power steering fluid to sliding surface of rotor
(1).
5) Install rotor to shaft, directing dot (3) marked side of
rotor facing up.
6) Install new snap ring (2) to shaft, then make sure to
fit snap ring into shaft groove securely.
NOTE
Never reuse the removed snap ring.
I2RH01630046-01
7) Apply power steering fluid to sliding surface of cam
ring (1).
8) Install cam ring to pump body. The tapered end of
cam ring (1) should face the side plate (2).
I2RH01630047-01
9) Apply power steering fluid to each vane (2).
10) Install vanes (12 pieces) (2) to rotor (1).
I2RH01630048-01
Power Assisted Steering System: 6C-18
I2RH01630049-01
I2RH01630050-01
I2RH01630051-01