Suzuki Liana RH413 Service Manual page 741

9) Install circlip (1) and confirm that circlip is installed in
groove securely.
Install needle bearing of resin cage type (2) and
apply oil to bearing.
With synchronizer outer ring (3), center cone (4) &
inner ring (5) put together and installed to 2nd gear
(6) as shown in figure.
[A]: Section A – A
10) Press-fit 3rd gear (2) and spacer (1) by using special
tools and hydraulic press.
NOTE
It is recommended to press-fit spacer and 3rd
gear first, and then 4th gear later separately
so that countershaft will not be compressed
excessively.
Special tool
(A): 09923–78210
(B): 09913–85210
3. 2nd gear
11) Press-fit 4th gear (2) by using the same procedure at
step 10).
12) Install left bearing cone (1) by using special tool and
hammer.
NOTE
For protection of bearing cone (3), always
support shaft with special tool as shown in
figure.
Special tool
(A): 09923–78210
(E): 09913–80113
I2RH01520064-01
I4RH01520036-01
Manual Transmission/Transaxle: 5B-32
I2RH01520066-01