Suzuki Liana RH413 Service Manual page 446

3C-13 Transfer:
"a": Pinion dummy height 40 mm (1.575 in.)
"b": Height from retainer installation face to top surface of pinion dummy
"c": Distance from retainer installation face to end face of bearing race
c) Tighten bevel pinion nut (special tool) so that
specified bearing preload is obtained.
NOTE
Before taking measurement, check for
rotation by hand more than 15 revolutions.
Tightening torque
Rotational torque of bevel pinion shaft
(Bearing preload): 0.50 – 1.50 N·m (0.05 –
0.15 kgf-m, 0.35 – 1.10 lb-ft)
1. Bevel pinion shaft
d) Measure height "b" in the figure by using vernier
caliper.
Calculate "c" by using measured value.
Distance "c" = Height "b" –
e) Obtain adjusting shim thickness by the following
equation.
Necessary
shim
thickness "f"
I4RH01330010-01
f) Select adjusting shim closest to calculated value
from among the following available sizes.
Available bevel pinion shim thickness
0.30, 0.60, 0.63, 0.66, 0.69, 0.72, 0.75, 0.78,
0.81, 0.84 and 0.87 mm (0.012, 0.024, 0.025,
0.026, 0.027, 0.028, 0.030, 0.031, 0.032, 0.033
and 0.034 in.)
I3RH01332055-01
2) Press-fit pinion shaft taper roller bearing outer races
(front and rear) by using special tools and hydraulic
press (1).
Special tool
(A): 09913–75821
(B): 09924–84510–002
(C): 09924–84510–005
(D): 09951–18210
Height "a" 40 mm
Distance
Distance
= +
"c" 61.2 mm
(2.409 in.)
"d": Pinion shaft mounting distance 61.2 mm (2.409 in.)
"e": Distance from end face of left case to axis of
reduction driven gear 79.25 mm (3.120 in.)
"f": Necessary shim thickness
(1.575 in.)
Distance
"d" "e"
–
79.25 mm
(3.120 in.)
I3RH01332056-01