Suzuki Liana RH413 Service Manual page 1017

Step
3 1) With ignition switch OFF, disconnect Special Tool (B)
and (C) then reconnect contact connector "L73" or "L74".
2) Disconnect side air bag (inflator) module connector (1)
from side air bag (inflator) module.
3) Check proper connection to side air bag (inflator)
module at terminal in connector.
4) If OK, then connect Special Tool (A), (B) and (C) to
connector.
Special tool
(A): 09932–76010
(B): 09932–75010
(C): 09932–78310
"L75", "L76"
With ignition switch ON, does DTC B1083 or B1087 still
exist?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to "DTC Clearance"), if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
(A)
(C)
1
(B)
STEERING WHEEL
I3RH0A820089-01
Air Bag System:
Yes
DTC: B1083
Repair short from
"WHT/RED" or "WHT/
GRN" wire circuit to
ground.
DTC: B1087
Repair short from "RED/
BLK" or "RED/YEL" wire
circuit to ground.
8B-92
No
Replace side air bag
(inflator) module
referring to "Side Air
Bag (Inflator) Module
Removal and
Installation".