Suzuki Liana RH413 Service Manual page 810

6C-19 Power Assisted Steering System:
11) Apply power steering fluid to O-ring (1).
12) Install O-ring (1) to pump body.
13) Apply power steering fluid to sliding surface of pump
cover and rotor.
14) Match the dowel pins (1) to the holes of the cover
plate (2) as shown, and then install pump cover to
pump body.
15) Gradually tighten pump cover bolts to specified
torque.
NOTE
After installing pump cover (1), check that
shaft can be turned by hand.
Tightening torque
Pump cover bolt (a): 28 N·m (2.8 kgf-m, 20.0 lb-
ft)
I2RH01630052-01
16) Apply power steering fluid to O-ring of terminal
switch.
17) Install pressure switch (1) to pump body.
Tightening torque
Pressure switch (b): 28 N·m (2.8 kgf-m, 20.0 lb-
ft)
18) Apply power steering fluid to relief valve (flow control
valve).
I2RH01630053-01
19) Install relief valve (flow control valve) to pump body.
20) Install flow control spring.
21) Apply power steering fluid to O-rings of plug.
22) Install O-rings to plug.
I2RH01630054-01
I2RH01630055-01