Dtc B1025: Driver Air Bag Initiator Circuit Short To Power Circuit - Suzuki Liana RH413 Service Manual

8B-49 Air Bag System:
Step
3 1) With ignition switch OFF, disconnect Special Tool (B)
and (C), then reconnect contact coil connector "L28"
located near the base of the steering column.
2) Remove driver air bag (inflator) module from steering
wheel referring to "Driver Air Bag (Inflator) Module
Removal and Installation".
3) Check proper connection to driver air bag (inflator)
module at terminals in connector "L81".
4) If OK, then connect Special Tool (B) and (C) to connector
"L81".
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78340
STEERING WHEEL
With ignition switch ON, does DTC B1024 still exist?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to "DTC Clearance"), if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.

DTC B1025: Driver Air Bag Initiator Circuit Short to Power Circuit

Wiring Diagram
GRN
1
2
[A]
[A]: Shorting bar
Action
(A)
"L81"
(D)
"L70"
"G14"
"L80"
3
RED
RED
BLK
7
3. "AIR BAG" fuse
1. From main fuse 4. SDM
2. Ignition switch 5. Contact coil assembly
Ignition switch OFF.
Replace contact coil
assembly referring to
"Contact Coil and
Combination Switch
Assembly Removal and
Installation in Section
6B".
(B)
I3RH0A820026-01
4
"L70"
+12V
L70-32
L70-27
L70-26
L70-31
6. Driver air bag (inflator) module
7. Ground for air bag system
Yes
Ignition switch OFF.
Replace driver air bag
(inflator) module
referring to
"Driver Air Bag (Inflator)
Module Removal and
Installation".
"L28"
5
GRN/RED
GRN
No
S3RH0A8204021
"L81"
6
I2RH01820026-01