Suzuki Liana RH413 Service Manual page 698

5A-150 Automatic Transmission/Transaxle:
54) After applying A/T fluid to direct clutch hub (1), install
it to planetary gear assembly.
55) After applying A/T fluid to input shaft rear thrust
bearing (1) and thrust bearing race (2), install them
into direct clutch hub (3).
3. Direct clutch hub
56) After applying A/T fluid to input shaft front thrust
bearing (1), install it to direct clutch assembly (2).
57) Apply A/T fluid to direct clutch assembly (1).
Install direct clutch assembly while rotating
clockwise and counter clockwise frequently to fit
clutch discs to mating hub.
NOTE
Before installation, align teeth of direct clutch
discs to facilitate installation.
I2RH0B510305-01
58) Check for correct installation of direct clutch
assembly as follows.
Measure distance "a" by using micrometer caliper (1)
and straightedge (2). If out of specification, remove
direct clutch assembly, direct clutch hub and reinstall
I2RH0B510306-01
them properly.
Distance between direct clutch assembly and
mating surface of transaxle case
"a": 10.4 – 11.4 mm (0.409 – 0.449 in.)
I2RH0B510307-01
"a"
I2RH0B510308-01
I2RH0B510309-01
"a"
1
2
I2RH0B510310-01