Driver Air Bag (Inflator) Module Inspection - Suzuki Liana RH413 Service Manual

3) Install driver air bag (inflator) module (3) to steering
wheel (4), taking care so that no part of wire harness
is caught between them.
4) Make sure that clearance between module (3) and
steering wheel (4) is uniform all the way.
5) Tighten driver air bag (inflator) module mounting bolt
(left side) (5) to specified torque first and then driver
air bag (inflator) module mounting bolt (right side) (6)
to specified torque.
Tightening torque
Driver air bag (inflator) module mounting bolt
(a): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
1. Driver air bag (inflator) module connector
2. Horn connector
6) Connect negative battery cable.
7) Enable air bag system. Refer to "Enabling Air Bag
System".

Driver Air Bag (Inflator) Module Inspection

WARNING
!
• Never attempt to disassemble or repair the
driver air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System" before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
undeployment of the air bag when
necessary.
• Never measure resistance of driver air bag
(inflator) module or disassemble it.
Otherwise, personal injury may result.
CAUTION
!
If air bag (inflator) module was dropped from
a height of 90 cm (3 ft) or more, it should be
replaced.
Check air bag (inflator) module visually and if any of the
following is found, replace it with a new one.
• Air bag being deployed
• Trim cover (pad surface) (1) being cracked
• Inflator case (2) being damaged or having been
exposed to strong impact (dropped)
I3RH0A820087-01
Air Bag System: 8B-102
S3RH0A8206006
I3JA01820115-01