Suzuki Liana RH413 Service Manual page 687

Adjustment
Differential side bearing preload
1) After applying A/T fluid to differential assembly, fit it
to transaxle case.
2) Install torque converter housing to transaxle case,
then tighten bolts (1) to specified torque.
Tightening torque
Torque converter housing bolt (a): 33 N·m (3.3
kgf-m, 24.0 lb-ft)
3) Measure bearing preload "a" by using a special tool.
Special tool
(A): 09928–06050
Differential side bearing preload measured as
starting torque
In the case of new bearing "a": 0.8 – 1.4 N⋅m (8.0
– 14.0 kg-cm, 0.58 – 1.01 lb-ft)
In the case of reused bearing "a": 0.4 – 0.7 N⋅m
(4.0 – 7.0 kg-cm, 0.29 – 0.51 lb-ft)
Automatic Transmission/Transaxle:
4) If bearing preload is out of specification, select shim
with suitable thickness from among the list below
and replace it. Then adjust differential side bearing
preload within specification.
Available shim thickness
Thickness
1.80 mm (0.070 in.)
1.85 mm (0.072 in.)
1.90 mm (0.074 in.)
1.95 mm (0.076 in.)
2.00 mm (0.078 in.)
2.05 mm (0.080 in.)
2.08 mm (0.081 in.)
2.11 mm (0.083 in.)
2.14 mm (0.084 in.)
2.17 mm (0.085 in.)
2.20 mm (0.087 in.)
2.23 mm (0.088 in.)
2.26 mm (0.089 in.)
2.29 mm (0.090 in.)
2.32 mm (0.091 in.)
I2RH0B510255-01
2.35 mm (0.092 in.)
2.40 mm (0.094 in.)
2.45 mm (0.096 in.)
2.50 mm (0.098 in.)
2.55 mm (0.100 in.)
2.60 mm (0.102 in.)
2.65 mm (0.104 in.)
2.70 mm (0.106 in.)
NOTE
Record measured value "a", because it is
necessary to adjust counter shaft bearing
preload.
5) Remove differential assembly.
Counter shaft bearing preload
1) After applying A/T fluid to countershaft assembly (1)
and differential assembly (2), fit them.
2) Install torque converter housing to transaxle case,
I2RH0B510256-01
then tighten bolts to specified torque.
Tightening torque
Torque converter housing bolt: 33 N·m (3.3 kgf-
m, 24.0 lb-ft)
5A-139
Identification mark
A
B
C
D
E
F
G
H
J
K
L
M
N
P
Q
R
S
T
U
V
W
X
Y
I2RH0B510257-01