Input Shaft Speed Sensor Removal And Installation; Input Shaft Speed Sensor Inspection; Transmission Fluid Temperature Sensor Removal And Installation - Suzuki Liana RH413 Service Manual

Input Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor connector (2).
3) Remove input shaft speed sensor (1) by removing its
bolt.
Installation
1) Apply A/T fluid to input shaft speed sensor O-ring.
2) Install input shaft speed sensor (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
3) Connect input shaft speed sensor connector (2) to
input shaft speed sensor (1).
4) Connect negative cable to battery.

Input Shaft Speed Sensor Inspection

1) Disconnect negative cable at battery.
S3RH0A5106011
2) Disconnect input shaft speed sensor connector (2).
3) Check resistance between input shaft speed sensor
(1) terminals.
Input shaft speed sensor resistance
Standard: 560 – 680 Ω at 20 °C (68 °F)
I2RH0B510047-01
Transmission Fluid Temperature Sensor
Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Lift up vehicle.
3) Remove engine under covers.
4) With engine is cool, remove drain plug and drain A/T
fluid.
5) Install drain plug. Refer to "A/T Fluid Change".
6) Remove A/T oil pan.
7) Remove oil strainer assembly.
8) Remove valve body assembly referring to
"Automatic Transaxle Unit Disassembly".
CAUTION
!
When pulling solenoid wire harness out of
transaxle case, take care not to damage
transmission fluid temperature sensor at
narrow exit of case.
I2RH0B510048-01
Careless sensor treatment might cause
sensor malfunction.
9) Remove solenoid wire harness (1).
Automatic Transmission/Transaxle: 5A-85
S3RH0A5106012
I2RH0B510049-01
S3RH0A5106059
I2RH0B510050-01