Differential Side Oil Seal Replacement - Suzuki Liana RH413 Service Manual

Differential Side Oil Seal Replacement

1) Lift up vehicle and drain automatic transaxle fluid.
2) Remove drive shaft joints from differential gear of
transaxle. Refer to "Front Drive Shaft Assembly
Removal and Installation in Section 3A" for
procedure to disconnect drive shaft joints.
For differential side oil seal removal, it is not
necessary to remove drive shafts from steering
knuckle.
NOTE
For 4WD model, transaxle is not equipped
with differential right side oil seal.
3) Remove differential side oil seal(s) by using
screwdriver or the like.
4) Apply grease to new differential side oil seal lip(s)
(1).
: Grease 99000–25030
5) Install new differential side oil seals (1) by using
S3RH0A5106019 special tool.
Special tool
(C): 09944–88220
(D): 09924–74510
6) Install drive shaft referring to "Front Drive Shaft
Assembly Removal and Installation in Section 3A".
I2RH0B510067-01
7) Pour A/T fluid referring to "A/T Fluid Change".
Automatic Transmission/Transaxle:
[A]: Right side for 2WD model only
[B]: Left side
5A-93
I2RH0B510068-01