Generator Symptom Diagnosis; Generator Test (Undercharged Battery Check) - Suzuki Liana RH413 Service Manual

Table of Contents

Advertisement

1J-4 Charging System:

Generator Symptom Diagnosis

CAUTION
!
• Do not mistake polarities of "IG" terminal
and "L" terminal.
• Do not create short circuit between "IG"
and "L" terminals. Always connect these
terminals through a lamp.
• Do not connect any load between "L" and
"E" terminals.
• When connecting charger or booster
battery to vehicle battery, refer to "Jump
Starting in Case of Emergency".
Trouble in charging system will show up as one or more
of the following conditions:
1) Faulty indicator lamp operation.
2) An undercharged battery as evidenced by slow
cranking or indicator dark.
3) An overcharged battery as evidenced by excessive
spewing of electrolyte from vents.
Charging Indicator Lamp Operation
Condition
Charge light does not
light with ignition ON and
engine off
Charge light does not go
out with engine running
(battery requires frequent
recharging)

Generator Test (Undercharged Battery Check)

This condition, as evidenced by slow cranking or low
specific gravity can be caused by one or more of the
following conditions even though indicator lamp may be
operating normal. The following procedure also applies
to cars with voltmeter and ammeter.
• Make sure that undercharged condition has not been
caused by accessories left on for extended period of
time.
• Check drive belt for proper tension.
• If battery defect is suspected, refer to "Battery
Description".
• Inspect wiring for defects. Check all connections for
tightness and cleanliness, battery cable connections
at battery, starting motor and ignition ground cable.
No-Load Check
1) Connect voltmeter and ammeter as shown in the
figure.
S3RH0A1A04002
Possible cause
Fuse blown
Indicator lamp (LED) faulty
Wiring connection loose
IC regulator or field coil faulty
Poor contact between brush and slip
ring
Drive belt loose or worn
IC regulator or generator faulty
Wiring faulty
S3RH0A1A04003
Noise from generator may be caused by loose drive
pulley, loose mounting bolts, worn or dirty bearings,
defective diode, or defective stator.
B: Generator output (Battery terminal)
C: C terminal
E: Ground
Correction / Reference Item
Check fuse.
Replace combination meter.
Tighten loose connection.
Check generator.
Repair or replace.
Adjust or replace drive belt.
Check charging system.
Repair wiring.
NOTE
Use fully charged battery.
1. Generator
2. Ammeter (between generator "B" terminal and battery (+) terminal)
3. Voltmeter (between generator "B" terminal and ground)
4. Battery
5. Load
6. Switch
I2RH0B1A0004-01
F: Field coil terminal
IG: Ignition terminal
L: Lamp terminal
I2RH011A0006-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Liana rh416

Table of Contents