Suzuki Liana RH413 Service Manual page 751

b) Using depth gauge, measure depth "a" down to
bearing outer race (1) and obtain difference with
dimension "b" of bearing retainer (2); "a" – "b" =
"c".
Special tool
(A): 09922–77241
c) Calculate shim thickness to be inserted into
differential side bearing.
Shim thickness = "c" + (0.085 to 0.114 mm)
(0.0033 to 0.0045 in.)
d) Select shim(s) to fit within calculated value.
Available differential side bearing shim
thickness
0.30 mm 0.78 mm
(0.012 in.) (0.031 in.)
0.87 mm 0.75 mm
(0.034 in.) (0.029 in.)
0.84 mm 0.72 mm
(0.033 in.) (0.028 in.)
0.81 mm 0.69 mm
(0.032 in.) (0.027 in.)
0.66 mm
(0.026 in.)
0.63 mm
(0.025 in.)
0.60 mm
(0.024 in.)
I3RH0A520059-01
Manual Transmission/Transaxle:
e) Place pinion bearings (1), spacer, shim(s) and
drive gear (2) to rear case and tighten new bevel
pinion nut to specified torque while holding drive
gear with special tool.
Tightening torque
Bevel pinion nut (a): 120 N·m (12.0 kgf-m,
87.0 lb-ft)
Special tool
(A): 09927–76030
f) Using torque wrench (1) and special tool,
measure bearing preload.
Pinion bearing preload
Standard: 0.5 – 1.3 N⋅m (5 – 13 kg-cm, 0.37–
0.94 lb-ft)
Special tool
(A): 09915–24550
NOTE
• Apply thin coat of gear oil to bearing
before measurement.
• Also before measuring preload, turn taper
bearing a few times to ensure its good
fitting.
g) Caulk bevel pinion nut.
2. Box (30 mm)
5B-42
I3RH0A520060-01
I3RH0A520061-01