23) Tighten plug (1) to specified torque.
Tightening torque
Plug (c): 60 N·m (6.0 kgf-m, 43.5 lb-ft)
24) Apply power steering fluid to O-ring of suction
connector.
25) Install O-ring (2) to suction connector (1).
26) Install suction connector (1) to pump body as shown
in the figure, and then tighten suction connector bolt
to specified torque.
Tightening torque
Suction connector bolt (d): 12 N·m (1.2 kgf-m,
8.5 lb-ft)
P/S Pump Inspection
Pump Body, Cover, Side Plate and Shaft
Check sliding surfaces of each part for wear and
damage. If any abnormality is found, replace pump
assembly.
IYSY01630061-01
Cam Ring
Check vane sliding surface of cam ring for wear and
damage. If any abnormality is found, replace pump
assembly.
I2RH01630057-01
Rotor and Vane
• Check sliding surfaces of rotor and vane for wear and
damage.
IWSE01632035-01
Power Assisted Steering System:
6C-20
S3RH0A6306017
I2RH01630040-01
I2RH01630041-01
I2RH01630042-01